Dr.Thiedig Digox 6, Руководство по эксплуатации

Страница: 29 / 62

29
5.2 The Digox 6 data logger
The Digox 6 has got 2 separate data storage: the
continuous data logger and the measuring point
data logger.
The data logger allows to save measuring values
and marginal conditions in the unit and to retrieve
them later via the data interface.
The continuous data logger allows to
continuously save the measuring values of a
measuring point in intervals that can be set. Three
series of measurements can be started in a
sequence. A total of 1,000 values can be saved.
NOTE :
The memory can be extended to accommodate up
to 3,000 measuring values.
This function can be enabled ex works or by our
maintenance service.
When using the continuous data logger, the
following conditions must be taken into account:
•
Independent of the amount of recorded
values, the data logger can be started three
times.
•
If the total amount of recorded measuring
values is attained, the measurement will be
stopped and a message will be displayed
(please refer to section 7).
If you would like to continue the measurement,
this message must be acknowledged.
The measuring point data logger is a part of the
TouchMemory system and is optional.
5.2.1 How to operate the continuous
Data logger
5.2.1.1 Selection of the interval
1. Mark the menu item DATA LOGGER in the
main menu and confirm with .
2. In the menu DATA LOGGER, confirm the
menu item CONTINUOUS LOGGER with
.
The following menu opens.
Figure 5.1
3. Press to confirm the menu item
CONFIGURATION.
The window for the logger configuration
opens.
Figure: 5.2
4. Use the cursor keys to set the calibration
interval.
Use
or
to select a number and to
mark the next digit.
Confirm the selected interval with .
NOTE:
The shortest interval to be selected is 5 seconds.