DPtech LSW3003 Series Industrial Ethernet Switch Installation Manual
Chapter 4Starting up the switch and upgrading software
1
Chapter 4Starting up the switch and upgrading
software
4.1 Starting up the Switch at the Initial Boot
4.1.1 Setting up a Configuration Environment
1.Connecting the switch to the terminal pc
Connect the RJ-45 connector of the console cable to the console port on the switch, and connect the
DB-9 female connector of the console cable to the serial port on the PC that is used for configuring the
switch, as shown in Figure4-1..
Figure4-1
Network diagram for configuring the device initial boot through console port
2. Setting terminal parameters
You should run HyperTerminal program on the terminal PC when you can configure the terminal PC.
Follow these steps to set terminal parameters on the PC (running Windows XP for example):
The HyperTerminal window displays the Connection Description dialog box, as shown in Figure 4-2.
