DPCAV ShutterBug Pro, Инструкция по эксплуатации

Страница: 9 / 16

ShutterBug Pro © 2007-2013 Page 9 Sep-15-2013
Step 3:
ŽŽŽ
Shutter Repeat Interval
Range: 1 to 30 seconds.
This entry configures the shutter repeat time. It is only observed when ShutterBug
Pro is used in the “Repeat” mode (see Step 5). Each press is one second, with a
maximum of thirty seconds. For example, for a rapidly repeating two second
shutter period, press twice. The timer begins at the end of each snapshot.
Step 4:
ŽŽŽŽ
Shutter Dwell Time
Range: 0.5 to 10 seconds (with half-second resolution).
This entry configures the Shutter (Stage-1) dwell time. Each press is one-half
second, with a maximum of ten seconds (twenty presses). For example, to set a
1.5 second Shutter time, press three times.
Step 5:
Ž
,,
Shutter Repeat / Hold Mode
Range: 1= Once, 2= Repeat, 3= Hold.
The shutter can be configure to operate in three different ways. They are as
follows:
Once: Press and release the shutter button once. Do not press again until
the next external trigger (R/C or external switch).
Repeat: Cycle the shutter to take rapid sequence of photos. Continue repeat
until the external trigger is released.
Hold: At the end of the snapshot, continue holding the shutter active until
the external trigger is released. Once the external trigger is removed,
the shutter will continue to stay active until the expiration of the
Shutter Dwell Time period. During the Standalone mode, the shutter
will remain active until the pushbutton switch is pressed.
Step 6:
ŽŽ
,,
Focus Dwell Time
Range: 1= Off, else 1 to 10 seconds (with half-second resolution).
This entry configures the focus dwell time. One press will disable Focus (Stage-2)
operation. Beyond that, each press is one-half second, with a maximum of ten
seconds (twenty presses). For example, to set a 1.5 second focus time, press
three times.