The appliance is fitted with an ash removal port
that can be opened.
The appliance is supplied with a scraper for
removing excess ash.
The appliance is suitable for an outside air
connection. The connection kit necessary for this
is sold separately.
Installation
Preparation
Please check the appliance for damage caused
during transport or any other damage or defects
immediately after delivery. The appliance is
attached to the pallet with screws at the bottom.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (top plate, fire-
resistant inner plates, ash pan) from the appliance
before you start installing the appliance. Removing
the top plate makes it easier to connect the
appliance.
The top plate is loose on the appliance and can
simply be lifted off the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door.
2. Remove the fire-resistant inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.
Connecting to the rear or upper
side
When connecting the appliance to a chimney, you can
choose the
top
or
rear
of the appliance.
Plug the outlet that you don't want to use with the
corresponding cover that was supplied.
Install the corresponding connection collar that
was supplied on the outlet that you want to use.
Sealant and materials are supplied.
1. Fit the connection collar (1) to the outlet fitted to
the chimney using the fixing materials.
Subject to change because of technical improvements
7
