Dover Triton FT5000, Руководство по подготовке места и установке

Страница: 59 / 60

5 9
TCP/IP (E
THERNET
)
Ethernet is the most popular LAN technology in use today. The IEEE standard
802.3 defines the rules for configuring an Ethernet network. It is a 10 Mbps,
CSMA/CD baseband network that runs over thin coax, thick coax, or twisted pair
cable.
The Ethernet option makes your FT5000 ATM LAN (Local Area Network) or WAN
(Wide Area Network) capable. The ATM functions that are normally performed via
the dial-up telephone system, such as customer transactions and remote monitor-
ing, can now be performed using existing in-house communications network. ATM
transaction processing and hardware monitoring functions are performed across a
shared network medium. Ethernet is popular because it strikes a good balance
between speed, cost and ease of installation. These benefits, combined with wide
acceptance in the computer marketplace and the ability to support virtually all popu-
lar network protocols, make the Ethernet option an ideal networking solution for
your FT5000 ATM.
TCP/IP C
ABLE
I
NSTALLATION
1. If the unit is ON , enter
Management Function>System
Parameters>Shut Down the
Terminal.
When prompted on the
screen, open the sleeve cabinet
and turn the power switch on the
power supply to the
OFF (0)
position..
2. Refer to the section on “Power and
Communication”. Route the
10Base-T (CAT-5) cable through
the cabinet cable access hole.
Secure cable inside vault area and
continue up to the cabinet sleeve
control area.
Figure 1. Rear view of TCP/IP
connector.
TCP/IP (E
THERNET
) C
ABLE
I
NSTALLATION
3. Connect the RJ-45 end of the CAT-5 cable to the TCP/IP connector located on
the docking board assembly as shown in Figure 1.
4. Secure cable into existing cable harness runs. Refer to the 5000- series
Configuration manual for programming Ethernet options.