10/16
NT 1101-B00 11 13 A15 - AS15 e
Remove clamps
7
and
9
in place and then hose boots
6
.
Operate the pump intermittently until the hose is comple-
tely out.
Disassemble cover
2
after removing screws
33
and was-
hers
34
.
Wash the inside of the pump body and the cover with
water or a cleaning product that is compatible with the
pump materials. Also wash the wheel (front + back).
4.1.2 REASSEMBLING THE HOSE
If this operation has not yet been carried out, remove
cover
2
, screws
33
and washers
34
.
Wash the inside of the pump body and the cover with
water or a cleaning product that is compatible with the
pump materials. Also wash the wheel (front + back).
After a visual inspection of the inside of the body and the
wheel, lubricate all the internal parts of the casing with
pump lubricant.
Assemble the cover
2
on the pump body
1
with screws
33
and washers
34
.
NOTES
If the pump is not re-assembled immediately, dry
unpainted surfaces and coat them with the pump
lubricant in order to protect them against corrosion.
Dispose of the drained products in accordance with
the rules and regulations in force.
NOTE
If the pump is not re-assembled immediately, dry
unpainted surfaces and coat them with the pump lubri-
cant in order to protect them against corrosion.
WARNING
Do not operate
without guard
in place.
NEVER INSERT THE HOSE OR RUN THE
PUMP WITHOUT ITS COVER AND ITS WIN-
DOW IN PLACE.
NOTE
Moderately tighten screws so as not to crack the
transparent plate of the cover. Once the screws are
tightened, the seal must be squeezed all over.
WARNING
Dangerous voltage.
Can cause
injury and death
.
DISCONNECT THE ELECTRICITY SUPPLY
BEFORE ANY MAINTENANCE OPERATION.
WARNING
Hazardous machinery
can cause severe
personal injury
or property damage.
THE HOSE CAN BE EXPELLED VIOLENTLY.
BE SURE NO ONE IS IN FRONT OF PUMP
PORTS.
4. MAINTENANCE OPERATIONS (continued)
