Douglas Dynamics Western Striker 98805, Руководство пользователя

Страница: 26 / 36

Lit. No. 74125/74126, Rev. 00 26 July 1, 2020
4. The hopper body should be slightly tilted toward
the chute end to prevent any rainwater from
pooling in the hopper.
5. Use blocking to ensure that the spreader is stable.
At the End of Each Season
or After Extended Storage
NOTE: The 99067 and 10923 gear boxes are
lubricated for life and do not require oil changes.
• Wash out the hopper and rinse off all external
surfaces.
• Apply dielectric grease on all electrical
connections to prevent corrosion.
• Lubricate all grease fittings with good-quality
multipurpose grease.
• Oil or paint any chipped or bare surfaces that are
not stainless steel.
FUSE REPLACEMENT
If a problem should occur and fuse replacement is
necessary, the replacement fuse must be of the same
type and amperage rating as the original. Installing a
fuse with a higher rating can damage the system and
could start a fire.
RECYCLE
When your spreader has performed its useful life,
many of its components can be recycled as steel.
Gear oil shall be disposed of according to local
regulations.
AFTER FIRST USE
Tighten all mounting fasteners.
AFTER EACH USE
• Wash out the hopper and rinse off all external
surfaces.
• Clean out any trapped/frozen material from
between the pintle chain and the vehicle bed.
• Apply dielectric grease on all electrical
connections to prevent corrosion.
• Lubricate all grease fittings with good-quality
multipurpose grease.
CAB CONTROL
Unplug the cab control from the control harness at
the end of the season or when the hopper is removed
from the vehicle.
STORAGE
The spreader can be stored in truck position on blocks
or stands. Make sure the supports are stable and the
ground beneath is firm enough that the spreader will
not shift over time.
1. Remove the chute from the hopper body. Store
the chute in a horizontal position. It may be placed
inside or on top of the hopper if desired.
2. Remove the hopper mounting bolts and tie-downs.
3. Attach slings to the four corner lift points and,
using a hoist, lift the hopper out of the vehicle.
Move the spreader to the storage location with the
hoist or lower it onto blocks and use a forklift to
move it to a secure location.
MAINTENANCE
CAUTION
Before lifting, verify that the hopper is empty
of material. The lifting device must be able to
support the spreader's weight as shown in
the Spreader Specifications table.
CAUTION
DO NOT leave unused material in hopper.
Material can freeze or solidify, causing unit to not
work properly. Empty and clean after each use.