Douglas Dynamics Western Striker 98805, Руководство пользователя

Страница: 19 / 36

Lit. No. 74125/74126, Rev. 00 19 July 1, 2020
OPERATING THE SPREADER – CAB CONTROL
Error Codes – Spreader Operation Stopped
Code Definition Possible Cause Suggested Solution
bb Bad button. Button is stuck.
Button was pressed while
vehicle ignition was entering
ACC or START mode.
Inspect control. Free up button.
Do not press any spreader cab control buttons
while the vehicle ignition is being engaged.
bH Bad hopper. Possible module or control
mismatch.
Replace control or module. Use only genuine
service parts. Contact authorized dealer.
CE No communication with
spreader module.
Loose connection.
Module lost power.
Confirm that spreader and control harnesses are
connected to the vehicle harness. Check power
to spreader module, all connections, fuses, and
power studs. Check that B port is plugged in.
CP Chute present fault. Chute is open.
Bad connection at chute position
mag switch. (Can occur when
driving on rough surface.)
Close the chute. Reset the control by pressing the
ON/OFF button.
If CP code continues to display, contact
authorized dealer.
Ct Control is hot. Cab temperature is too high.
Control overheated.
Turn spreader OFF and allow control to cool off.
Setup Codes
Code Definition Procedure
Cb Calibrate the Empty Hopper setting. With control in ON mode, press and hold the left control knob until the
Cb code displays. Calibration cycle is automatic.*
Cc Clear calibration data for Empty Hopper
setting; clear EH code.
Press the right control knob to clear all calibration data during the
calibration cycle.
LS Set LED brightness level. With control in Ready mode, press and hold left control knob to get
LS code. Release pressure and turn left control knob to desired
brightness setting. Wait for confirming
SL
code to display.*
SL Confirms that LED brightness level has
been reset.
* For full instructions, see the "Setup Procedures" section.
Information Codes
Code Definition Response
dU Spreader is in dump mode:
• Material chute is open.
• Back Dump buttons are enabled.
To operate the dump function, see instructions in the Operating the
Spreader section of this manual.
If
dU
code displays when the material chute is closed and latched,
contact authorized dealer.
EH
Empty hopper (beep will sound). Check hopper for material.
Recalibrate Empty Hopper setting as described above for
Cb
code.
Lb
Low battery. Hopper module is sensing
< 10V. ( Lb becomes an error code
when module senses < 6V.)
Refer to the
Lb
row under "Error Codes" (next table).
CAB CONTROL CODES
Table continues on next page.