Douglas Dynamics Western Striker 98805, Руководство пользователя

Страница: 16 / 36

Lit. No. 74125/74126, Rev. 00 16 July 1, 2020
SPINNER DRIVE ASSEMBLY
INSTALL SPINNER DRIVE ASSEMBLY
NOTE: Complete the assembly installation in the
Install Chute Assembly section before proceeding
with these instructions.
1. Carefully set the spinner drive assembly on the
ground. Orient it in operating position as shown
below.
2. Install the lock pins found in the parts bag
to attach the spinner drive assembly to the chute
supports.
Install the top lock pin first
, using the
lower holes in the chute supports. Secure each
lock pin with a cotter pin.
3. Connect the spinner motor harness to the female
connector extending from the rear of the hopper.
Lock
Pins
Cotter
Pins
Install Tie‑Down Straps
Install tie-down straps from the tie-down loops on the
spreader body to the truck frame. Use one strap per
loop, pulling diagonally away from the hopper body.
Construct Sill Spacer
Measure the distance from the front end of the hopper
sill to the front of the vehicle bed and make a spacer
from 2" x 8" lumber to fit that area.
Failure to install a spacer could result in damage
to the spreader.
Front of
Truck Bed
Measure distance.
Spacer
Built to Fit
Measured
distance.
2"x 8" Construction
Fit to vehicle.
18"