Lit. No. 40694, Rev. 04
16
May 1, 2021
MOUNTING SNOWPLOW (ON)
NOTE: Use dielectric grease to prevent corrosion
on all connections.
1. Slowly drive vehicle forward to engage mount
adapter into A-frame.
2. Move power switch to center or "OFF" position.
3. Plug in electrical harnesses.
4. Push and hold power switch RIGHT and push UP
and hold Arm/Blade Operation switch. Arm will
engage mount adapter and pull snowplow toward
vehicle.
MOUNTING SNOWPLOW TO VEHICLE
WARNING
Keep 8' clear of the blade when blade is being
raised, lowered, or angled. Do not stand
between the vehicle and blade or directly in
front of blade. If the blade hits or drops on
you, you could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever mounting or
removing the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
5. Rotate and release the hitch pin. The hitch pin is
fully engaged when the pin handle is against the
pin guide plate.
6. Repeat Step 5 on the passenger's side. Rotate
and release the hitch pin.
7. While holding the power switch RIGHT, push
DOWN and hold Arm/Blade Operation switch. Arm
will disengage mount adapter to relieve tension on
the stand.
8. Pull the stand handle up. The stand will lift o
ff
the
ground. Pull the stand pin out. Rotate the stand up
until the stand pin seats into the upper hole on the
A-frame. The pin must lock into the upper A-frame
hole.
9. Repeat Step 8 on the passenger's side.
10. Move the power switch to the left or "PLOWING"
position.
Light
Tower
Power
Switch
Arm / Blade
Operation
Switch
Switch
Label
ARM/BLADE
OPERATION
POWER
OFF
Raise
Lower
Plowi
n
g
A
rm/Bl
a
d
e
Opera
ti
o
n
OFF
48207
Power Switch
Arm/Blade
Operation Switch
Hitch Pin
Mount
Adapter
Arm
A-Frame
Stand
Upper Hole
Stand Pin
Stand Handle
Light Tower
Boot
Blade
Shoe
ON
Hitch
Pin
Pin
Handle
Mount
Adapter
Pin
Guide Plate
Содержание Blizzard 7600HD
Страница 2: ......
Страница 4: ......
Страница 6: ......
Страница 39: ...Lit No 40694 Rev 04 39 May 1 2021 NOTES...