Douglas Dynamics Blizzard 7600HD, Руководство пользователя

Страница: 21 / 40

Lit. No. 40694, Rev. 04 21 May 1, 2021
SNOWPLOW HEADLAMP CHECK
With all electrical plugs connected, check the
operation of vehicle and snowplow headlamps.
Connecting and disconnecting the electrical plugs
should switch between the vehicle and snowplow
headlamps as follows:
• Electrical plugs DISCONNECTED—Vehicle
headlamps function normally.
• Electrical plugs CONNECTED—Vehicle headlamp
functions transfer to the snowplow headlamps. On
some Daytime Running Lamps (DRL) systems,
both the vehicle and snowplow headlamps will
function.
Aiming the Headlamps
• Aim the snowplow headlamps with the snowplow
mounted and raised in the transport position. See
Aiming Headlamp Beams in the Maintenance
Section for instructions.
• Aim the vehicle headlamps with the snowplow
removed from the vehicle.
Lights Results
Parking Lamps
Both vehicle and snowplow
lamps should be ON.
Right Turn Signal
Both vehicle and snowplow
lamps should be ON.
Left Turn Signal
Both vehicle and snowplow
lamps should be ON.
DISC SHOE ADJUSTMENT
Recommended Shoe Adjustments
For gravel surfaces: The bottom surface of the shoe
should be 1/4" to 1/2" below the cutting edge.
For hard surfaces (concrete or asphalt): The
bottom surface of the shoe should be even with the
cutting edge.
1. Raise the blade 1 foot o ff the road surface, turn
the control OFF, and from in front of the blade,
place stand assembly under the cutting edge.
2. Turn the control ON and lower the blade onto
the stand assembly. Turn the control and vehicle
ignition OFF.
3. Remove the linchpin, and slide the disc shoe down
and out of the shoe holder.
4. Remove one or more washers from the shoe
stem, and reinstall the shoe into the shoe holder.
5. Place the removed washers onto the shoe stem
above the shoe holder.
OPERATING YOUR SNOWPLOW
WARNING
Blade can drop unexpectedly. Place blade on
stand assembly. Failure to do so could result
in serious personal injury.
Washers
Disc Shoe
Spacer
Shoe Holder
Linchpin