DOTWORKZ D2 COOLDOME, Инструкция по эксплуатации продукта

Страница: 3 / 31

2
PRODUCT INSTALLATION
PRECAUTIONS – WARNINGS – ADDITIONAL INFORMATION
(RETAIN THIS DOCUMENT)
ƒ
The External Nut on All electrical wire feed Glands must be tightened to create a weather
tight seal prior to putting D2 in service. Failure to create this seal may result in water
incursion into enclosure. This may lead to electrical shock, product failure and damage to
electrical systems installed within enclosure, including but not limited to damage to camera,
heater and blower circuitry, cooling circuitry and other systems installed in unit.
ƒ
All screws on hinged lower must be tightened to create seal on enclosure. Failure to create
this seal may result in water incursion into enclosure. This may lead to electrical shock,
failure and damage to electrical systems installed within enclosure, including but not limited
to damage to camera, heater and blower circuitry, cooling circuitry and other systems
installed in unit.
ƒ
Do not over tighten any Screws, Stand Offs, or other fasteners on this unit. Failure to heed
this warning will cause damage or failure of the D2 enclosure.
ƒ
Be sure to take extra care to Protect Lens of unit prior to and during installation, and during
service. Suspension packaging box is a handy platform to protect lens and enclosure, while
installing camera and accessory electronics before installation. Failure to protect lens will
adversely affect product performance.