Dot-Spot brilliance-midi, Руководство оператора

Страница: 22 / 28

Preparing the connection
Bear the supply cable and a free cable routing in mind. The connection cable must be led back-
wards away from the spot. It must not be laid forward past the spot across the installation hole of
the spot. If possible, the supply cable of the spot should be laid in an empty conduit.
Assembly
Connecting and inserting the spot
Prior of inserting the spot, run the connection cable through the installation hole and if necessary
the empty conduit towards the power supply. There should be a cable loop behind the spot allowing
it to be pulled out at any time.
Connect the spot (see below) and test the installation.
Press the spot into the installation hole or the installation sleeve. Ensure that the retaining springs
fit neatly into the installation hole; if necessary, slightly push the springs in the directions of the
housing.
Connection
Attention: The design of the complete system and of the required power supplies must be carried
according to the protective low voltage SELV prescriptions!
The brilliance-midi (narrow) , brilliance-mini and dome-spot are supplied with DC power and
dimmed via a separate PWM signal (pulse width modulation). A PWM signal (S-PWM) is required for
each light color. The PWM input has the following characteristics:
The switching point of the luminary between on and off for the PWM level is not defined: Ideally it
should be worked with a switching impulse between ground and open contact or optionally with an
impulse between ground and operating voltage. A PWM signal differing from the operating voltage
is not allowed.
Free cabling
The connect is made according to the assignment tables. The connection must be carried out ac-
cording to the required IP classification.
22
en
PWM line connected to ground (-) LED on
PWM line open LED off
PWM line connected to operating voltage (+) LED off
PWM frequency = 0 to 1,000 H
brilliance-midi (narrow), brilliance-mini and dome-spot white / monochromatic
Wire color
Assignment
red + 24 Volts
blue S-PWM
black ground (-)