Dot Hill Systems SANnet II 200 FC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 125 / 210

Chapter 8 Troubleshooting Your Array 8-7
2. Depending on whether the cause of the alarm is a failed component or a controller
event and which application you are using, silence the alarm as specified in the
following table.
Pushing the Reset button has no effect on controller event alarms and muting the
beeper has no effect on failed component alarms.
8.3 RAID LUNs Not Visible to the Host
Caution –
When mapping partitions to LUN IDs, there must be a LUN 0. Otherwise,
none of the LUNs will be visible.
By default, all RAID arrays are preconfigured with one or two logical drives. For a
logical drive to be visible to the host server, its partitions must be mapped to host
LUNs. To make the mapped LUNs visible to a specific host, perform any steps
required for your operating system. For host-specific information about different
operating systems, see:
■
Appendix E for the Solaris operating system
■
Appendix F for Windows 200x Server or Windows 200x Advanced Server
■
Appendix G for a Linux server
■
Appendix H for an IBM server running the AIX operating system
■
Appendix I for an HP server running the HP-UX operating system
8.4 Controller Failover
Controller failure symptoms are as follows:
■
The surviving controller sounds an audible alarm.
■
The RAID Controller Status LED on the failed controller is amber.
Table 8-6 Silencing Alarms
Cause of Alarm To Silence Alarm
Failed Component
Alarms Use a paper clip to push the Reset button on the right ear of the array.
Controller Event
Alarms Using the controller firmware: From the Main Menu, choose system
Functions → Mute beeper . Refer to the
SANnet II Family RAID Firmware
User’s Guide
fore more information.
Using SANscape: Refer to “Updating the Configuration” in the
SANscape
User’s Guide
for information about the Mute beeper command.
Using the SANscape CLI:
Run mute [ controller ].
Refer to the
SANscape CLI User’s Guide
for more information.