Dot Hill Systems SANnet II 200 FC, Инструкция по установке, эксплуатации и обслуживанию

Страница: 110 / 210

7-2 SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005
■
SANscape Alert provides event monitoring and notification. Refer to the SANscape
Alert User’s Guide for information.
■
SANscape Command-Line Interface (CLI) provides script-based management. Refer
to the
SANscape CLI User’s Guide for SANscape CLI information.
For details on how to install SANscape, SANscape Alert, or SANscape CLI software,
refer to the
SANscape Software Installation Guide.
The documentation CD provides the related user guides, with detailed installation and
configuration procedures for SANscape and SANscape Alert.
7.1.1 Out-of-Band Connections
With the out-of-band serial port connection, you can use a Solaris
tip
session or a
Microsoft Windows terminal emulation program to access the firmware application.
For details, see “Setting Up the Serial Port Connection” on page E-1.
With the out-of-band Ethernet port connection, you can use the
telnet
command to
access the firmware application. For details, see “Setting Up Out-of-Band
Management Over Ethernet” on page 4-28.
You can also configure an array over the Ethernet connection with the SANscape CLI
and the SANscape software.
Caution –
If you assign an IP address to an array to manage it out-of-band, for
security reasons consider using an IP address on a private network rather than a
publicly routable network.
7.1.2 In-Band Connections
With in-band host connections, you can use SANscape software or the SANscape
Command-Line Interface (CLI).
■
Refer to the SANscape User’s Guide for the in-band setup procedures.
■
Refer to the SANscape CLI User’s Guide for in-band and out-of-band commands.
■
Refer to the SANscape Software Installation Guide for all SANnet II 200 installation
instructions for all host-based software.
7.1.3 Other Supported Software
Multipathing for FC, SATA, and SATA SE arrays is provided by SANpath software.
Multipathing software is required when you have multiple connections from a server to
an array (directly or through a switch), want to avoid a single point of failure, and are