Dot Hill Systems AssuredSAN 4544, Руководство по установке

Страница: 19 / 100

AssuredSAN Ultra48 Series Setup Guide 19
4844 controller module — rear panel components
Figure 6 shows CNC ports configured with SFPs supporting either 4/8/16 Gb FC or 10GbE iSCSI. The
SFPs look identical. Refer to the CNC LEDs that apply to the specific configuration of your CNC ports.
Figure 6 4844 controller module face plate (FC or 10GbE iSCSI)
Figure 7 shows CNC ports configured with 1 Gb RJ-45 SFPs.
Figure 7 4844 controller module face plate (1 Gb RJ-45)
NOTE: See CNC ports used for host connection on page 11 for more information about CNC technology. For
CNC port configuration, see the “Configuring host ports” topic within the RAIDar User Guide or online help.
1 CNC ports used for host connection or replication
(see Install an SFP transceiver on page 95)
2 CLI port (USB - Type B) [see Appendix D]
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 mini-SAS expansion port
1 CNC ports used for host connection or replication
(see Install an SFP transceiver on page 95)
2 CLI port (USB - Type B) [see Appendix D]
3 Service port 2 (used by service personnel only)
4 Reserved for future use
5 Network port
6 Service port 1 (used by service personnel only)
7 Disabled button (used by engineering only)
(Sticker shown covering the opening)
8 mini-SAS expansion port
CACHE
CLI
CLI
LINK ACT
6Gb/s
SERVICE−1 SERVICE−2
PORT 0 PORT 1 PORT 2 PORT 3
5
2 3 6 8
1 7
4
= FC LEDs
= 10GbE iSCSI LEDs
CACHE
CLI
CLI
LINK ACT
6Gb/s
SERVICE−1 SERVICE−2
PORT 0 PORT 1 PORT 2 PORT 3
5
2 3 6 8
1 7
4
= FC LEDs
= 1Gb iSCSI LEDs (all CNC ports use 1 Gb RJ-45 SFPs in this figure)