Dorner Mfg. Corp.
12
851-620 Rev. A
7400 Ultimate Series End Drive Conveyors
Installation
8.
Insert the pull pins
(Figure 28, item 1)
on the tension
end of the conveyor.
Figure 28
9.
If no more travel is available, remove one or more belt
links to take up the tension. Refer to “Standard Belts:
Replacing a Section of Belt” on page 17.
Belt Return Installation
Typical Belt Return Components
(Figure 29)
.
Figure 29
1.
Attach the chain return shoes
(Figure 30, item 1)
to the
return shaft
(Figure 30, item 2)
.
Figure 30
2.
Slide the return shaft
(Figure 31, item 1)
up and
through the large slot
(Figure 31, item 2)
in the frame
(picture shown without the belt or wear strips).
Figure 31
3.
Push up on the return shaft
(Figure 31, item
1)
and slide
the notched end of the shaft through the small slot on the
opposite side of the frame.
1
Return shaft
2
Chain return shoe
1
1
2
1
2
1
2
