22
23
Locking Clip
1
2
3
5
Thread both vehicle lap
and shoulder belts through
the slot (as shown) and
out other side. Buckle.
Pull up on shoulder belt
until all slack is out and lap
belt is tight.
Rebuckle belt. Lap belt
portion should now be
tight. If not, remove
locking clip and repeat all
steps.
Grasp both vehicle belts
together just behind the
buckle plate and unbuckle.
NOTE:
If the buckle plate
ends up behind the child
restraint, grasp the belts to
the outside of the child
restraint, as close to the
buckle plate as possible.
Thread both portions of
the vehicle belt onto the
locking clip, as close to the
buckle plate as possible.
NOTE:
Remove the locking clip when the seat belt is
not being used with a child restraint. The locking clip is
located on the back of the seat.
A locking clip will not fix
all types of seat belt problems.
Before you put your child restraint in the vehicle, buckle
the lap/shoulder belt. Pull on the lap belt portion. If it
loosens or slips, you must either use a locking clip to
hold the seat belt tight or move the child restraint to
another seating location.
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s buckle plate.
4
4358-3395E Touriva 5/15/06 9:42 AM Page 25
Page 13 of 26 Dorel Touriva / Comfort Ride / Regal Ride / Deluxe Conv (5/06)
