31
Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint rear-
facing in the back seat.
NOTE:
Tuck the top
anchorage strap’s hook
under the child restraint.
Fasten one LATCH belt
hook to the anchor in the
vehicle seat located in the vehicle seat bight. Repeat for
other side of child restraint. See your vehicle owner’s
manual for more information.
With weakest hand at belt
path, tilt and push the
child restraint forward and
back, and from side to
side. If the LATCH belts
do not loosen, your child
restraint should be secure.
NOTE:
Some “play” from
front to back or about an
inch from side to side is
acceptable.
If the child restraint does not remain tight, do not use
the child restraint in this seating location with this
LATCH system.
5
WARNING
!
4
To remove LATCH:
Remove child from
restraint. Press down
firmly on adjuster side of
child restraint and push
in on release button on
adjuster to release
tension as shown.
Unhook LATCH from
bar.
After checking for hot
seat and buckles, place
child in child restraint.
See “Securing Your
Child in the Child
Restraint” section.
LATCH hooks MUST be securely
fastened. Failure to do this can result in
serious injury or death.
Rear-Facing Installation with
LATCH: Install in Vehicle
1
2
3
Push down firmly on the
child restraint and pull up
on the loop to tighten belt.
Rear Facing Use:
5-35 lbs.
(2.3-16 kg),
19-36” (48-91 cm)
30
4358-3395E Touriva 5/15/06 9:42 AM Page 33
Page 17 of 26 Dorel Touriva / Comfort Ride / Regal Ride / Deluxe Conv (5/06)
