Introduction
Instruction Manual DR-FC
51
gis
7
Starting up and
shutting down
7.1
Introduction
Topics covered in this chapter:
•
•
7.2
Starting up
Start-up the water heater as follows:
1. Fill the water heater. See chapter
2. Open the gas valve (see
’Figure 4.1 Installation diagrams’
).
3. Switch on the power to the water heater using the isolator between the water
heater and the power supply.
4. Turn the control panel
ON
by setting ON/OFF switch to
position I
.
The display will now show
INTERNAL CHECK
for about 10 seconds, then
go to the main menu.
5. Activate the “ON mode” by going through the following steps:
-
Press once on the DOWN button (
L
) to position the cursor (
»
) beside
ON
, then press
E
. The display shown in figure
appear.
Figure 7.1
Control panel
INTERNAL CHECK
Figure 7.2
Internal check
MENU
»OFF
^ ON
È WEEK PROGRAM
Figure 7.3
Main menu
gis
Содержание DR-FC 25
