Safety Regulations & Engine Specifications
- 3 -
1.1.3. Regulations designed to prevent damage to engine and premature wear
1) Never demand more of the engine than it was designed to yield for its intended purpose.
z
Detailed information on this can be found in the sales literature. The injection pump must not be
adjusted without prior written permission of DHI.
2) If faults occur, find the cause immediately and have it eliminated in order to prevent more serious of
damage.
3) Use only genuine DHI spare parts. DHI will accept no responsibility for damage resulting from the
installation of other parts which are supposedly “just as good”.
4) In addition to the above, note the following points.
z
Never let the engine run when dry, i.e. without lube oil or coolant.
z
Use only DHI-approved service products (engine oil , anti-freeze and anticorrosion agent).
z
Pay attention to cleanliness. The Diesel fuel must be free of water. See “Maintenance and care”.
z
Have the engine maintained at the specified intervals.
z
Do not switch off the engine immediately when it is warm, but let it run without load for about 5
minutes so that temperature equalization can take place.
z
Never put cold coolant into an overheated engine. See “Maintenance and care”.
z
Do not add so much engine oil that the oil level rises above the max. marking on the dipstick. Do
not exceed the maximum permissible tilt of the engine. Serious damage to the engine may result
if these instructions are not adhered to.
z
Always ensure that the testing and monitoring equipment (for battery charge, oil pressure, coolant
temperature) function satisfactorily.
z
Comply with instructions for operation of the alternator. See “Commissioning and operation”.
z
Do not let the raw water pump run dry, If there is a risk of frost, drain the pump when the engine is
switched off.
1.1.4. Regulations designed to prevent pollution
1) Engine oil, filter elements, fuel filters
z
Take old oil only to an oil collection point.
z
Take strict precautions to ensure that oil does not get into the drains or into the ground. The
drinking water supply could be contaminated.
z
Filter elements are classed as dangerous waste and must be treated as such.
2) Coolant
z
Treat undiluted anti-corrosion agent and / or antifreeze as dangerous waste.
z
When disposing of spent coolant comply with the regulations of the relevant local authorities.
1.1.5. Notes on safety in handling used engine oil
Prolonged or repeated contact between the skin and any kind of engine oil decreases the skin.
Drying, irritation or inflammation of the skin may therefore occur. Used engine oil also contains
dangerous substances which have caused skin cancer in animal experiments. If the basic rules of
hygiene and health and safety at work are observed, health risks are not to the expected as a result of
handling used engine oil.
Содержание P158LE -III
