DoorKing 1506-086, Инструкция по установке и эксплуатации, Страница: 7 / 22

1506-065-K-6-17 5
1.3 Flush Mount
IMPORTANT: Be sure to clean out the cabinet of
any debris that can cause a short.
All necessary wiring should be connected to the
14-pin terminal. See Section 1.4 Terminal Wiring.
Mount rough-in box into the pilaster, wall or
kiosk. Run conduit inside wall into bottom of
rough-in box if desired. Use appropriate
hardware (Not supplied) to secure the rough-in
box in place.
Mount in a Pilaster,
Wall or Kiosk
Bolt flush box into
the rough-in box with
4 supplied bolts.
See spec page in
front of this manual
for dimensions about
your model.
Rough-In Box
Conduit
in W
all
Flush
Box
1.2 Surface Mount
Surface mount cabinet can be mounted directly to a
wall or pilaster. They can be post mounted using a
DoorKing mounting post (there are several different
styles available). Be sure keypad is securely mounted
and is not subject to continuous vibration from
closing doors or gates.
Use existing 4 holes in surface
mount cabinet box to bolt on a
DoorKing mounting post.
Use the hardware that is
supplied with the
mounting post.
Note: A gooseneck
mounting post
anchored in concrete
does not make a
good ground.
Mount on a Post
Run ALL wires that will be
needed during the cabinet
installation and connect to
14-pin terminal. See Section
1.4 Terminal Wiring.
Use the 4 existing holes in
the cabinet. Run conduit
inside of wall or pilaster. Use
appropriate hardware to
mount the cabinet (Not
supplied). Be sure that the
mounting hardware does not
protrude into the cabinet
where it could cause a short.
Mount Directly
to a Wall or Pilaster
Plastic screw anchors
for masonry if required.
(Not supplied)
1/2” Conduit
IMPORTANT: Be sure to clean out the cabinet of any
debris that can cause a short.
All necessary wiring should be connected to the 14-pin
terminal. See Section 1.4 Terminal Wiring.
See spec page in front of
this manual for dimensions
about your model.