DoorKing 1506-086, Инструкция по установке и эксплуатации, Страница: 13 / 22

1506-065-K-6-17 11
2.8 Programming Five-digit Entry Codes
1. Press
*
0 9 and enter the MASTER CODE. [
*
0 9 _ _ _ _ (beep)]
2. Choose and enter a five-digit entry code, then press
*
. [ _ _ _ _ _
*
(beep)]
3. Repeat step 2 to enter up to 5 additional five-digit entry codes one at a time.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
Five-digit entry codes are entered on the Keypad. DO NOT press # first when using five-digit entry codes. When the door input
is activated by the five-digit entry code, the relay will deactivate one second after this input is activated, regardless of the
programmed strike time . Five-digit entry codes are NOT affected by the time zone inputs or hold boundaries .
ONLY SIX (6) five-digit entry codes can be programmed.
2.11 Five-digit Entry Code Divide Number
The five-digit entry codes can be made to activate either Relay 1 or Relay 2 by programming a five-digit “divide” number.
Five-digit entry codes EQUAL TO or LESS THAN the divide number will activate Relay 1 , while five-digit entry codes GREATER
THAN the divide number will activate Relay 2 . If NO divide number is programmed (enter # # # # # in step 2), then Relay 2 acts
as an alarm by-pass relay, activating .1 second PRIOR to Relay 1 , and deactivating .1 second AFTER Relay 1 .
Important: Both five-digit and four-digit entry codes must be programmed to operate in the same mode . If a divide number is
programmed for the five-digit codes, then a divide number MUST also be programmed for the four-digit entry codes (see section
2.7).
Factory setting is NO divide numbers programmed (# # # # #).
Note: To delete an existing five-digit entry code divide number, enter # # # # # in step 2. This will cause relay 2 to act as an alarm
by-pass relay provided that the existing four-digit divide number has also been deleted (see section 2.7).
1. Press
*
1 3 and enter the MASTER CODE. [
*
1 3 _ _ _ _ (beep)]
2. Choose and enter a five-digit divide number, then press
*
. [ _ _ _ _ _
*
(beep)]
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.10 Erase ALL Five-digit Entry Codes
1. Press
*
1 1 and enter the MASTER CODE. [
*
1 1 _ _ _ _ (beep)]
2. Enter 9 9 9 9 , then press
*
. [ 9 9 9 9
*
(beep)]
3. A long beep after approximately 10 seconds indicates that all five-digit entry codes are
deleted and programming ends.
CAUTION: This programming sequence will delete ALL five-digit entry codes that have been previously programmed in.
This cannot be UNDONE .
2.9 Erase a Five-digit Entry Code
1. Press
*
1 0 and enter the MASTER CODE. [
*
1 0 _ _ _ _ (beep)]
2. Enter an existing five-digit entry code to be erased, then press
*
. [ _ _ _ _ _
*
(beep)]
3. Repeat step 2 to erase additional existing five-digit entry codes one at a time.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
CAUTION: This programming sequence will delete an INDIVIDUAL five-digit entry code that has been previously
programmed in. This cannot be UNDONE .