DoorKing 1506-086, Инструкция по установке и эксплуатации, Страница: 6 / 22

1506-065-K-6-17 4
1.1 Remove Faceplate from Cabinet
Important Notices
SECTION 1 - INSTALLATION
Do not mount the 1504/1506 keypad to a moving gate, or immediately next to a gate panel or pedestrian gate. Continuous
vibration from slamming gates and vibration can cause damage to the system over time.
WARNING! If the keypad is used to activate a vehicular gate operator, it must be mounted a minimum of 6 feet away from
the gate and gate operator, or in such a way that the user cannot come into contact with the gate or gate operator while
using the device.
Store faceplate in a safe place
during installation.
1. Open housing with key (surface or flush mount). 2. Remove locknuts from hinge on faceplate to remove faceplate.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
MAS
TE
R COD
E
ON
1506-010
Locknuts
Discharge any static BEFORE
removing the faceplate by
touching a proper ground device.
• Prior to starting the installation, become familiar with the instructions, illustrations and wiring diagrams in this manual.
• Never mount this device to a moving gate or gate panel, or next to a gate that causes vibration to the fence, such as a spring-
loaded pedestrian gate. Continuous vibration from moving or slamming gates can cause damage to the unit in time.
• If this system is used to activate an automatic vehicular gate operator, it must be mounted in such a way that the user
cannot come into contact with the gate or the gate operator when the device is used. We recommend that the unit be
installed a minimum of 6 feet away from the gate and gate operator.
• Always disconnect power when performing service on the system.
• If the unit is mounted outdoors, be sure that the wiring to the unit is designed for direct underground burial, even if the wire is
run inside a conduit.
• Surge suppression is recommended on the low voltage input power line.
• Instruct the end user on the safe and proper operation of this device.
• Instruct the end user to read and follow these instructions. Instruct the end user to never let children play with or operate
any access control device. This Owner’s Manual is the property of the end user and must be left with them when
installation is complete.