DoorBird D21 Series, Руководство по установке

Страница: 11 / 60

ENGLISH
11
Only related for devices with call button(s):
4 PIN (SWITCH)
Use the yellow cable to connect the button to the IP Video Door Station.
2 PIN (BELL)
BELL
BELL
We offer feature-rich IP door chimes (e.g. DoorBird A1061W), which can be securely
connected via your network (LAN / WIFI / WAN) to this device. Alternatively you can
connect a conventional door chime using this relay contact.
Switching relay, max. 24 V DC / AC, 1 Ampere. The relay contact can be used to connect
a conventional door chime. Very high-impedance electronic door chimes with melody
are currently not supported (ca. >= 10k Ohm, may ring permanently under certain
circumstances).
Additional feature: The switching relay blocks temporarily if a visitor keeps the
call button pressed permanently.
The power supply for the door chime must be installed separately. Should you have any
questions, please contact the manufacturer of your door chime. You can find compatible
door chimes at www.doorbird.com/support
Some door chimes operate with 110-240 V DC / AC. Do not connect such
door chimes to this relay contact. The device is immediately destroyed and
life-threatening injuries can occur.
Please take care when connecting the cables and wires. Connecting the cables and wires the wrong
way may damage the device. Wires without insolation material must not protrude out of the green
screw connection terminal, it may lead to electrical short and damage the device.
The yellow, green, and red cables that lead out from the side of the Main Electrical Unit must only be
used to connect components certified by Bird Home Automation.
NOTICE
NOTICE
STEP 9: ACTIVATING THE DEVICE
Switch on the power leading to the assembly location
again. If you use PoE, make sure to switch on power
of the PoE-Switch or PoE-Injector you have connected
the device to.
NOTICE
Do not power the device simultaneously via
the power supply from the power supply
unit (mains adaptor) and the power supply
via PoE.
You can see if the device is powered by checking the
Diagnostic-LED, which lights up after about 30 to 60
seconds after the power is connected. The device is
ready for operation (booting up process, any software
updates, etc.) once it has emitted a short diagnosis
sound from the integrated loudspeaker. This may last
for up to 5 minutes. If the Diagnostic LED does not
light up, please check the power supply. Please
also check whether you have used a wall-plug power
supply and not PoE and whether you have connected
the positive pole and negative pole to the device
correctly.
STEP 8: ASSEMBLING THE FRONT PLATE
Assemble the front plate of the device to the
mounting housing (backbox) of the device.
1.) Pull the front
panel into the
mounting
housing
(backbox)
2.) Push the
front panel
up.
3.) Insert the
security
screws.