DOMUSA TEKNIK Fusion Hybrid Oil, Инструкция по установке и эксплуатации

Страница: 15 / 52

13
Before switching on the heat pump, the control panel must be connected to the external machine.
To do this, pass the cable that is supplied inside the heat pump (located alongside the probe
harness) to the interior of the
Fusion Hybrid Oil module. The hydraulic module has a series of cable
glands at the rear, through which it is possible to insert such cables into the module.
Finally, the connectors of the cable and the control panel should be connected at their ends.
A
cable with sufficient length should be provided inside the module , in such a manner that it is
possible to open the front of the equipment without having to disconnect said cable and facilitate
any maintenance operation inside.
The cable supplied with the heat pump is 5 metres long. Where necessary, it can be extended up to
a maximum distance of 100 metres (section between 0.5÷1.25 mm
2
).
DANGER: When handling the electrical installation, make sure that both the module and
the Dual Clima heat pump are disconnected from the mains.
Provide a sufficient length of cable inside the module in order to facilitate the
opening of the front.
4.8 Configuring the Heat Pump
To properly configure and manage the operation of the DUAL CLIMA heat pump, please carefully read
the “Installation and Operating Instructions Manual” supplied alongside the
DUAL CLIMA
heat pump.
Nevertheless, in order to obtain all the features for which the supporting module has been provided, it
should be ensured at least that the DHW service and the Heating and/or Cooling service are activated
by adjusting the DIP-Switch (
SW1 ) of the control panel of the heat pump.
In addition, for the correct management of the DUAL CLIMA heat pump with the support module, it
will be essential to set the value 3 through parameter P27 of the Technical menu of the DUAL
CLIMA heat pump and value 0 through parameter P26 of the Technical menu of the DUAL CLIMA .