INSTALLATION MANUAL
EN
WARNING:
The Led MODULE, the power supply cable or any switch used, are not
replaceable, therefore in case of damage the device must be entirely
substituted.
WARRANTY:
The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty's general terms and
conditions for this device are available at
www.domusline.com
The luminosity level obtained will be saved until the next adjustment.
The output cable of
POLAR SE SDM
can handle a load of max. 72W @
24VDC included the absorption of the device figure 4.
OPERATION POLAR SE:
POLAR SE
(F) is a switch-free spotlight, then it must be turned on via
a remote switch that can be placed on the
POLAR SE SDM
(wired in
the MASTER version) as shown in figure 4 or it can be assigned to a
separate switch connected to the primary of the converter as shown
in figure 3, or to a remote socket where to connect the converter.
ATTENTION: POLAR SE SDM
must be connected directly to the
electronic feeder and it must not be connected after other electronic
switches.
The sensor must not be installed near electromagnetic sources, heat
sources or exposed to direct sunlight.
WHC VERSION OPERATION (colour change):
POLAR SE WHC2
has a light source with 2 selectable colour
temperatures (3000-4000K). To select, proceed as follows:
Move the hand quickly across the sensor (C) 3 times, with the lamp
on, to select the required colour temperature.
