PowerGate™ Modem User’s Manual
© 2001 Domosys Corporation
page 10 of 16
UM-PWG-0100-02
Chapter 3 Installation and Configuration
3.1
Connecting the PowerGate™ Modem
The PowerGate™ modem is configured as a Data Communication Equipment (DCE). Use a
regular DB-9 male to DB-9 female serial cable to connect to your equipment serial port.
Figure 3 Connecting the PowerGate™ Modem
Follow the steps below to install the PowerGate™ modem system (see Figure 3 Connecting the
PowerGate™ Modem):
1. Connect the power adapter DIN connector on the PowerGate™ modem. This connector
mates with the DIN connector on the rear of the modem.
Connect your host device (computer) to the PowerGate™ modem serial port. If the host is a
computer, connect the RS-232 standard modem cables between the COM1 or COM2. If the host
device is a DCE, use a null modem cable.
2. Plug the power adapter unit into any electrical outlet close to your computer.
3. Turn ON the PowerGate™ modem by toggling the main power switch, located on the rear
of the modem, to the upper position (ON).
