Instruction manual
5
1.
Holding the head and insert it in the
inlet with one hand, revolves toward
left and insert it into by pushing down
the locking knob and taking care to
match the slot, and then turn to the
left to lock then release the locking
knob. (fig. 1 and 2).
2.
Place the feed screw into the head,
long end first, by turning the feed
screw slightly until it is set into the
motor housing (fig.3).
3.
Place the cutting blade onto the feed
screw shaft with the blade facing the
front as illustrated (fig.4). If it is not
fitted properly, meat will not be
ground.
4.
Place the desired cutting plate next to
the cutting blade, fitting protrusions in
the slots (fig.5).
5.
Support or press the center of the
cutting plate with one finger then
screw the fixing ring until tight with
another hand (fig.6). Do not over
tighten.
6.
Place the hopper plate on the head and fix into position.
7.
Locate the unit on a firm place.
8.
The air passage at the bottom and the side of the motor housing should be kept free and not
blocked
