7
OPERATION
A. The Function Of The Remote Control
STEP 1
Up Button
(not used)
LED +
Down Button
LED −
LED Button
BUTTON
FUNCTION
Up
Retracts the awning when the button is held
Stop
Not used in this application
Down
Extends the awning when the button is held
LED
Turns LED light(s) on and off
LED −
Dims LED light(s)
LED +
Brightens LED light(s)
For Motorized RVs Only: Make sure the awning auto-
matically closes when starting the RV .
B. Adjusting The Vibration Sensor (If Applicable)
Do
NOT
rely on the vibration sensor to prevent damage to the awning . The awning should
ALWAYS
be closed
when unattended or when strong [rain / wind / etc.] is expected.
Do
NOT
hang any items from or block the travel of the hardware arms or awning when the vibration sensor is
installed .
IMPACT OR CRUSH HAZARD . Keep your hands, arms, head or torso clear of the awning hardware during peri-
ods of rain, wind, etc. These conditions may cause the vibration sensor to unexpectedly activate and retract the awning. Failure
to obey this warning could result in death or serious injury .
The sensitivity of the vibration sensor can be set from 1 (most sensitive) to 9 (least sensitive) . Settings 0 and 5 are for
programing only, and are not active vibration settings .
• Refer to "D . Mounting The Vibration Sensor (If Applicable)" on page 6 to remove the vibration sensor from the front
channel .
STEP 1
Back of Sensor
Battery
Compartment
STEP 2
Sensor Dial
ALWAYS
confirm functionality of the vibration
sensor after any changes or adjustments are made . Refer to
step 3 to test vibration sensor operation .
C. Other Useful Information
1 .
For safety purposes, the vibration sensor sends a signal to the receiver every 60 minutes to confirm functionality. If for
any reason (removal, low battery, etc), that signal is not received after 60 minutes, the awning will retract automatically .
2 . The vibration sensor will not function if not attached to the sensor base .
3 .
To extend the awning, depress the down button until the awning is fully deployed. Then, releasing the down button will
cause the awning to stop, and jog back to the final use position.
