3
GENERAL INFORMATION
REQUIRED HARDWARE
(1) 3/16" x 1/2" Pop Rivet (optional - installer-supplied)
BASIC COMPONENTS
3316520 .201 Wireless Receiver
• Receiver Wire Harness
• Dry Contact Switch Wire Harness
• 3316518 .201 Remote Control
• Miscellaneous Wire Connectors
• Dry Contact Switch (Power)
OPTIONAL COMPONENTS AND KITS
3316519 .205 Vibration Sensor (Black)
3316519 .202 Vibration Sensor (White)
REQUIRED TOOLS
Drill
Phillips Screwdriver / Bit
#11 (0 .191") Drill Bit
7/16" Hex Nut Driver / Bit
Riveting Tool
Needle Nose Pliers
Flat-Bladed Screwdriver / Bit (Small)
Wire Cutter
A. Receiver Control Range
L1 IN THE AIR
L2 WITH CONCRETE WALLS
EMISSION FREQUENCY
12 V
200 m (656 .17 ft)
35 m (114 .83 ft)
433 .92 MHz
INSTALLATION
ELECTRICAL SHOCK HAZARD . Disconnect 120 Vac power from RV . Failure to obey this warning could result
in death or serious injury .
Install a 15 A fuse (installer supplied) at fuse panel for positive (+) 12 Vdc power supply ( RED wire) to product .
Otherwise, damage to unit could occur .
Disconnect the positive (+) 12 Vdc terminal from supply battery . Otherwise, damage to unit could occur .
Disconnect power for ALL procedures under this section . Use a grommet (installer supplied) or equivalent protec-
tion when routing wire through the RV’s [roof / floor / walls].
A. Installing The Receiver
1 . Determine the receiver location .
2 . Route the wiring .
If using dry contact switches, route the installer-supplied wiring inside the RV from the receiver location to the dry contact
switch installation site .
