5
INSTALLATION
C. Programming The Vibration Sensor (If Applicable)
Complete each programming step within four seconds of the previous step to keep the receiver in pairing mode . If the
receiver resets, restart the programming process .
• When installing a vibration sensor, complete the steps in "B . Programming The Remote Control" on page 4 then
start with STEP 1 of this procedure without delay .
STEP 1
Sensor Base
Vibration Sensor
Battery
Compartment
Front of
Sensor
Back of
Sensor
STEP 2
Sensor Dial
Set to 0
Vibration Sensor
Battery Compartment
STEP 3
Back of
Remote
Control
x1
a.
b.
x1
x1
x2
a . Press the P2 button once . The wireless receiver
beeps once and the awning jogs .
b . Press the P2 button a second time . The receiver
beeps once .
STEP 4
Vibration
Sensor
Battery
Compartment
Programming
Button
x1
x5
x1
x1
a . Press the vibration sensor programming button . The
sensor beeps once, the wireless receiver beeps five
times, and the awning jogs .
STEP 5
Sensor Dial
Set to 5
Vibration
Sensor Battery
Compartment
STEP 6
Programming
Button
The Awning
retracts.
x1
x1
a . Set the vibration sensor dial to the desired level of
detection (see Operation, "B . Adjusting The Vibration
Sensor (If Applicable)" on page 7) .
b . Press the vibration sensor programming button once .
The sensor beeps once, and the awning retracts .
