Dometic PerfectView CAM 360 AHD, Руководство по установке

Страница: 23 / 452

EN
CAM360 Installing the video system
23
Proceed as follows:
➤
Temporarily position the cameras using adhesive strips or suction cups as shown
in fig.
9
, page 6 to fig.
b
, page 6.
➤
Temporarily connect the camera system according to the circuit diagram
(fig.
c
, page 7).
➤
Perform a basic calibration as a test (refer to chapter “Calibrating the 360° view”
on page 33).
➤
Mark the positions of the cameras.
Securing the cameras
A
Observe the following mounting instructions:
•
The most secure type of attachment is with screws fitted through the body.
Please observe the following instructions:
–
There must be sufficient space behind the chosen installation location to be
able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any
holes made (e.g. by using screws and sealant and/or spraying the outer
attachment parts with sealant).
– The location on the body where you wish to attach the camera must be rigid
enough to allow the camera to be tightly fastened.
•
Check beforehand whether electrical cables can be damaged when the drill
passes through the material (fig.
2
, page 4).
•
If you are not sure about the location you have chosen, ask your vehicle manufac-
turer or dealer.
NOTICE!
•
Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
•
Deburr all drill holes that have been made in the sheet metal and
apply rust-protection.
•
Place a cable sleeve in all sharp edged ducts.
CAM360-I-DE.book Seite 23 Freitag, 9. Juni 2017 6:50 18