Dometic HC302 Series, Инструкция по установке и эксплуатации

Страница: 21 / 76

EN
HC302, HC502
Troubleshooting
21
9 Troubleshooting
Water in or under the refrigerator
Display signals
Fault Possible cause Remedy
Water is leaking into the
inside of the refrigerator. The condensate drain duct is clogged. Clean the drain.
Medicines are preventing the water
from flowing to the collector. Make sure that medicines
do not touch the rear wall.
Water is leaking onto the
floor. There is too much water in the water
container. Clean the water container.
Signal Explanation
General error
The display blinks each
second.
The display shows alternately the current inner temperature and
the active error code (fig.
2 1, page 2) (E1 or E2, see below).
Sensor failure
The display blinks and
shows “E1”.
The minimum and maximum values will be kept as the last known
values.
Low battery
The display blinks and
shows “E2” alternately
with the current temper-
ature.
The minimum and maximum inner temperatures are still visible
and will be updated from the current inner temperature reading.