Dometic Frigo DC 2500, Руководство по установке

Страница: 36 / 124

EN
Installation of stationary cooling (optional) Frigo DC
36
10 Installation of stationary cooling
(optional)
!
I
10.1 Installing battery charger
I
➤
Mount the terminal bridge under the three positive terminal connections
using three M3 x 5 bolts (fig.
o
, page 14).
➤
Hold the device at the installation position you have selected in the vehicle,
e.g. on the rear wall or under the seat.
➤
Mark the attachment points.
➤
Fasten the battery charger by screwing one bolt through each hole in the
holders provided.
➤
Connect the connection cables to the battery charger (fig.
o
, page 14).
Observe the circuit diagram (fig.
g
, page 10 and supplementary sheet).
A
➤
Set the four dip switches (see supplementary sheet).
➤
Switch on the main switch of the battery charger on the rear (ON position).
CAUTION!
• The stationary cooling 230 V connection may only be operated with a fault
current protected switch with a nominal current of 30 mA and an earthed,
splash water-protected mains socket.
• If the mains fuse or the fault current switch trips when connecting the sta-
tionary cooling, then the cause of this must be rectified by a specialist elec-
trician.
• The device plug safety cap must always be closed when the stationary cool-
ing function is not is use.
• When using a cable drum this must be completely unwound. Otherwise
the cable can heat up too much and cause a cable fire.
NOTE
Safety instructions and information regarding the installation and operation of
the battery charger are available in the accompanying installation and operat-
ing manual.
NOTE
Observe the accompanying installation and operating manual for the battery
charger.
NOTICE!
Ensure that the connection cable for the battery charger and the main switch
are secured in their position from vibrations during driving, to prevent a failure
of the stationary cooling.
Frigo_DC-I-West.book Seite 36 Mittwoch, 24. Juni 2020 11:27 11