DuraSea Rooftop Installation & Operations Manual
Precautions
L-3075 ENGLISH
3
Installation Instructions
P
RECAUTIONS
1.
Read Installation and Operating Instructions carefully before attempting to start this unit installation.
2.
Dometic Corporation (Dometic) will not be liable for any damages or injury incurred due to failure in following these
instructions.
3.
DO NOT add any devices or accessories to this unit except those specifically authorized in writing by Dometic.
4.
This equipment must be serviced by qualified personnel and some states require these people to be licensed.
C
HOOSING
P
ROPER
L
OCATION
F
OR
T
HE
U
NIT
This unit is specifically designed for installation on the roof of a boat. Mount only with front of unit facing the bow (the vented end
should face aft). See Figure 4.
When determining your cooling requirements, the following should be considered:
•
Size of boat
•
Window area (increases heat gain)
•
Amount of insulation in walls and roof
•
Geographical location where the boat will be used
•
Personal comfort level required
Normal locations
-The unit is designed to fit over an existing roof vent opening.
Other locations
- When no roof vent is available or another location is desired, the following is recommended:
•
For one-unit installation:
The unit should be mounted as far aft as possible and centered from side to side.
•
For two-unit installation:
Install both units as far aft as possible and centered from side to side.
It is preferred that the unit be installed on a relatively flat and level roof section, but up to a 15° tilt is acceptable.
A
FTER
L
OCATION
H
AS
B
EEN
S
ELECTED
•
Check for obstructions in the area where unit will be installed. See
Figure 1.
WARNING:
Improper installation may damage equipment, could endanger life, cause serious injury and/or property damage.
Содержание DuraSea
Страница 20: ......
