Dometic CAM80CM, Инструкция по установке и эксплуатации

Страница: 17 / 196

CAM 80CM Mounting the camera
EN
17
If you would like to attach the camera with threaded screws fitted through the
construction (fig.
c
, page 6)
A
➤
Drill Ø 4.5 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the camera bracket on with the M5 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer threaded screws.
Creating a through-hole for the camera connection cable (fig.
d
, page 6)
I
A
➤
Drill a hole of Ø 16 mm near the camera.
➤
Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
➤
Place cable sleeves in all sharp edged ducts.
Mounting the camera
A
➤
Push the camera into the camera bracket.
➤
Attach the camera loosely with the two screws M3 x 8 mm in the slots (fig.
e
, page 6).
➤
Align the camera provisorily so that the lens is at an angle of approx. 50° to the perpendicular
axis of the vehicle (fig.
f
, page 7).
A
NOTICE! Risk of damage!
Ensure that that nuts cannot be pulled through the body shell when they are tightened.
Use larger washers or metal plates if necessary.
NOTE
If possible, use available openings – such as ventilation grilles – to feed the connection
cables through. If there are no existing openings, you must drill a hole with a
16 mm diameter.
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill head to come out
NOTICE! Risk of damage!
Only use the screws supplied to mount the camera in the camera bracket. Longer
screws will damage the camera.
NOTICE! Risk of damage!
Never mount the camera without the camera guard.
CAM80CM-IO-16s.book Seite 17 Donnerstag, 28. Juli 2016 2:20 14