Dometic CAM80CM, Инструкция по установке и эксплуатации

Страница: 15 / 196

CAM 80CM Mounting the camera
EN
15
8 Mounting the camera
8.1 Tools required
For installation and assembly you will require the following tools:
•
Drill bit set (fig.
1
1, page 3)
•
Drill (fig.
1
2, page 3)
•
Screwdriver (fig.
1
3, page 3)
•
Set of ring or open-ended spanners (fig.
1
4, page 3)
•
Measuring ruler (fig.
1
5, page 3)
•
Hammer (fig.
1
6, page 3)
•
Centre punch (fig.
1
7, page 3)
To make and test the electrical connection , the following tools are required:
•
Diode test lamp (fig.
1
8, page 3) or voltmeter (fig.
1
9, page 3)
•
Crimping tool (fig.
1
10, page 3)
•
Insulating tape (fig.
1
11, page 3)
•
Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
8.2 Mounting the camera
!
I
Observe the following installation instructions:
•
To provide a suitable viewing angle, the camera must be attached at a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting the camera.
•
Ensure that the installation location of the camera is sufficiently firm (e.g. to prevent the camera
from being knocked down by branches that may brush over the roof of the vehicle).
CAUTION!
Select a location for the camera and attach it so securely that it cannot under any
circumstances fall off and injure bystanders (e.g. by being knocked off by branches
brushing over the roof of the vehicle).
NOTE
If installing the camera alters the vehicle height or length specified in the vehicle
documents, your vehicle must be inspected by the appropriate authorities.
Make sure that you are in possession of documents verifying that your vehicle has
passed this inspection.
CAM80CM-IO-16s.book Seite 15 Donnerstag, 28. Juli 2016 2:20 14