Dometic CAM80CM, Инструкция по установке и эксплуатации

Страница: 16 / 196

Mounting the camera CAM80CM
EN
16
•
Mount the camera bracket horizontally and in the middle of the rear of the vehicle (fig.
0
,
page 6).
•
The most secure type of attachment is with screws fitted through the body. Please observe the
following instructions:
– There must be sufficient space for the mounting procedure behind the chosen installation
location.
– Suitable measures must be taken to prevent water penetrating through any holes made
(e.g. by using screws and sealant and/or spraying the outer attachment parts with a
sealant).
– The location on the body where you wish to attach the camera must be rigid enough to
allow the camera to be tightly fastened.
•
Check beforehand that there is sufficient room for the drill head to come out on the other side
(fig.
2
, page 4).
•
If you are not sure about the location you have chosen, consult the vehicle manufacturer or
dealer.
I
When mounting the camera, proceed as follows:
➤
Hold the camera on the chosen location and mark at least two different points for the drill holes
(fig.
a
, page 6).
➤
Using a hammer and centre punch, gently pre-punch the previously marked points to prevent
the drill head from slipping off.
If you want to screw on the camera with self-tapping screws (fig.
b
, page 6)
A
➤
Drill Ø 4 mm holes at the points you have just marked.
➤
Deburr all drill holes and apply rust-protection.
➤
Screw the camera bracket on with the 5 x 20 mm self-tapping screws.
NOTE
We recommend greasing the threads of the bolts to prevent corrosion.
NOTICE! Risk of damage!
The holder may only be attached to steel panels with a minimum thickness of 1.5 mm
using self-tapping screws.
CAM80CM-IO-16s.book Seite 16 Donnerstag, 28. Juli 2016 2:20 14