Dometic 944 07.00 Series, Инструкция по установке и эксплуатации

Страница: 5 / 12

5
EN
Trim Line Awning Installation
3. With the white side of the awning fabric facing up,
slide the entire length of the awning rope into the
groove in the front bar.
4. Roll up the awning into the attached awning bag.
5. Secure the rolled awning by tying the awning bag
webbing straps.
6. Zip the awning bag closed.
5 Installation
WARNING: IMPACT OR CRUSH HAZARD.
Failure to obey the following warnings could
result death or serious injury:
• Verify that the drill point screws are inserted and the
awning bag is securely fastened to the awning rail
before traveling.
• Verify that the mounting surface on the RV is flat, that
it has solid structural backing where the fasteners
penetrate the surface, and that it will safely and
securely support the product. Otherwise, the
product may become unstable and could detach or
collapse.
NOTICE: Always use sealant on (clean) parts and
surfaces where fasteners enter the RV roof and/or walls.
Otherwise, water leakage could occur.
I When unzipping the bag or untying the poles, be
sure to hold the poles so that loose poles do not fall
out of the bag.
This section describes how to install the awning.
5.1 Installing the Awning
e
q
w
3 Preparing the Awning Rail
q
Before
e
After
w
Screwdriver
1. Prepare the awning rail to accept the awning by
prying open the lead end of the awning rail with a
screwdriver.
e
q
w
4
Positioning the Awning on the Awning Rail
q
Screw
e
Awning Rail
w
Vinyl Welt
2. Insert the vinyl welt of the awning bag into one end
of the awning rail, sliding the awning into the desired
position.