Dometic 944 07.00 Series, Инструкция по установке и эксплуатации

Страница: 4 / 12

4
EN
General Information Trim Line Awning
3 General Information
This section provides general information about the
awning and its components.
I The images used in this document are for reference
purposes only. Components and component
locations may vary according to specific product
models. Measurements may vary ±0.38 in. (10 mm).
3.1 Tools and Materials
Dometic recommends that the following tool be used
while installing the appliance.
Recommended Tools
Screwdriver
4 Preinstallation
CAUTION: LIFTING HAZARD.
Use proper lifting technique and control when
lifting this product. Failure to obey this caution
could result in personal injury.
I Start all screws into the holes before tightening the
nuts. Do not overtighten the nuts.
This section describes how to assemble the joiner tubes
and attach the awning fabric.
4.1 Assembling the Awning
q
w
r
t
e
1 Part Identification
q
Flat Washer
r
Screw
w
Locknut
t
Connector Joint
e
Front Bars
1. Secure the front bars to the connector joints using the
provided screws, flat washers, and locknuts.
w
e
r
q
2 Inserting the Awning into the Front Bar
q
Groove (Side View)
e
Groove in Front Bar
w
Awning Fabric
r
Rope
2. Unroll the awning fabric on a flat, clean surface.