9
C. Lift and place the unit over the prepared opening using
the gasket on unit as a guide. The blunt end goes
toward the rear of the RV.
DO NOT SLIDE THE UNIT. THIS MAY DAMAGE THE
DO NOT SLIDE THE UNIT. THIS MAY DAMAGE THE
DO NOT SLIDE THE UNIT. THIS MAY DAMAGE THE
DO NOT SLIDE THE UNIT. THIS MAY DAMAGE THE
DO NOT SLIDE THE UNIT. THIS MAY DAMAGE THE
NEOPRENE GASKET ATTACHED TO THE BOTTOM
NEOPRENE GASKET ATTACHED TO THE BOTTOM
NEOPRENE GASKET ATTACHED TO THE BOTTOM
NEOPRENE GASKET ATTACHED TO THE BOTTOM
NEOPRENE GASKET ATTACHED TO THE BOTTOM
AND CREATE A LEAKY INSTALLATION.
AND CREATE A LEAKY INSTALLATION.
AND CREATE A LEAKY INSTALLATION.
AND CREATE A LEAKY INSTALLATION.
AND CREATE A LEAKY INSTALLATION.
D. Place 3106475.001, Electronic Kit and
________________, Return Air Cover Kit, inside the
RV. These cartons contain mounting hardware for the
air conditioner and will be used inside the RV.
This completes the outside work. Minor adjustments can
be done from the inside of the RV if required.
7.
7.
7.
7.
7. INST
INST
INST
INST
INSTALLA
ALLA
ALLA
ALLA
ALLATION OF AIR
TION OF AIR
TION OF AIR
TION OF AIR
TION OF AIR
CONDITIONER
CONDITIONER
CONDITIONER
CONDITIONER
CONDITIONER
A.
A.
A.
A.
A. INSTALLATION OF CEILING TEMPLATE
INSTALLATION OF CEILING TEMPLATE
INSTALLATION OF CEILING TEMPLATE
INSTALLATION OF CEILING TEMPLATE
INSTALLATION OF CEILING TEMPLATE
1)
Check gasket alignment of the Air Conditioner
over roof opening and adjust if necessary. Unit
may be moved from below by slightly lifting and
sliding.
2)
Reach up into the return air opening of the Air
Conditioner and pull the unit electrical cord down
for later connection.
C.
C.
C.
C.
C. COMFORT CONTROL CENTER INSTAL-
COMFORT CONTROL CENTER INSTAL-
COMFORT CONTROL CENTER INSTAL-
COMFORT CONTROL CENTER INSTAL-
COMFORT CONTROL CENTER INSTAL-
LATION
LATION
LATION
LATION
LATION
1)
Carefully remove the base plate from the Comfort
Control Center. This may be accomplished by
inserting a screwdriver under the tab on the bot-
tom edge of the front cover and gently prying. (See
Figure below).
2)
Insert the telephone cable through the hole in the
base plate and mount the plate to the wall with the
two screws provided. Check the alignment to
ensure level installation.
3)
Install the control cable RJ-11 connector into the
back of the Comfort Control Center and gently
press the _______ onto the base plate.
6.
6.
6.
6.
6. PLA
PLA
PLA
PLA
PLACING
CING
CING
CING
CING THE AIR CONDITIONER
THE AIR CONDITIONER
THE AIR CONDITIONER
THE AIR CONDITIONER
THE AIR CONDITIONER
ON THE ROOF
ON THE ROOF
ON THE ROOF
ON THE ROOF
ON THE ROOF
A.
Remove the Air Conditioner from the carton
and discard.
B.
Place the Air Conditioner on the roof.
USE CARE IN LIFTING. THIS UNIT WEIGHS APPROXI-
USE CARE IN LIFTING. THIS UNIT WEIGHS APPROXI-
USE CARE IN LIFTING. THIS UNIT WEIGHS APPROXI-
USE CARE IN LIFTING. THIS UNIT WEIGHS APPROXI-
USE CARE IN LIFTING. THIS UNIT WEIGHS APPROXI-
MATELY ONE HUNDRED (100) POUNDS.
MATELY ONE HUNDRED (100) POUNDS.
MATELY ONE HUNDRED (100) POUNDS.
MATELY ONE HUNDRED (100) POUNDS.
MATELY ONE HUNDRED (100) POUNDS.
BE KIND -
BE KIND -
BE KIND -
BE KIND -
BE KIND -
RECYCLE ALL CARDBOARD
RECYCLE ALL CARDBOARD
RECYCLE ALL CARDBOARD
RECYCLE ALL CARDBOARD
RECYCLE ALL CARDBOARD
FRONT
Return A ir Grille
Return A ir
Cover
Ceiling
Template
Divider
Plate
