20
MAINTENANCE
A.
Air Filter
Periodic cleaning or replacement of the air conditioner/heat pump air filters
is required.
NEVER
run the air conditioner without the air filter in place. This
may plug the unit evaporator coil with dirt and may substantially degrade the
performance of the unit over time.
When a system fan run time exceeds 1000 hours the filter icon is displayed in the
LCD. (See section, “D. Quick Reference To LCD Icons” on page (5).) When this
occurs wash the filter with soap and warm water. Let dry and reinstall.
To reset the fan run time and clear the filter icon, hold the
INSIDE TEMP
and
°
F /
°
C
buttons for 3 seconds. This will clear the fan run time for the current zone
selected.
B.
Dometic CCC 2 Thermostat
DO NOT
spray water directly on the CCC 2 thermostat.
DO NOT
use solvents
for cleaning.
Clean the CCC 2 thermostat with a moist soft cloth.
SERVICE
In the unlikely event the unit fails to operate or operates improperly, check the fol
-
lowing before calling your service center.
● If RV is connected to a motor generator, make sure the motor generator is run
-
ning and producing power.
● If RV is connected to a power supply by a land line, make sure the line is sized
properly to run air conditioner load and it is plugged into the power supply.
● Check the 120 Vac fuse or circuit breaker to see if it is open. Make sure fuse is
not burnt, or circuit breaker is ”ON” and not activated.
● Check the 12 Vdc fuse or circuit breaker to see if it is open. Make sure fuse is not
burnt, or circuit breaker is ”ON” and not activated.
● After the above checks, call your local service center for further help. This unit
must be serviced by qualified service personnel only.
When calling for service, always give the following:
● Unit Model Number and Serial Number found on Identification Label located on
the Base Pan of unit bottom. It is necessary to remove the return air cover to
expose the rating plate.
● Electronic Control Kit Part Number and Serial Number found on Identification
Label located on the side of the Kit. This kit is mounted in the return air cavity and
can be exposed by removing the return air cover.
