Assembly / Filling of cylinder core / Masterkey wafers
22
Masterkey wafers
MK wafers are used to permit locking variations in accordance with the specified
locking plan. A lock cylinder without MK wafers can only be locked by one key, while
a lock cylinder with MK wafers can be locked by different keys.
You can use the figures in the cylinder assembly fittings table to identify which and
how many MK wafers you must use. The figures that are listed vertically beneath a
core pin number (in grey) tell you which gradations are required for the relevant core
pin in the cylinder.
As can be seen from the table, a double gradation (MK gradation) is always allowed
for each pin position in locking systems. Once defined, the relevant even (0, 2, 4, 6)
or odd (1, 3, 5, 7) value for each pin position cannot be changed. The mounting di-
rection of the MK wafers is not important.
MK wafers
0
3
1
4
1
6
2
5
4
5
6
P1
P2
P3
P4
P5
P6
Fig. 14: Masterkey wafers
MK wafers are
0.8 mm, 1.6 or 2.4 mm long.
One MK gradation corresponds to 0.8 mm.
Here:
You must place
3 MK wafers
(
2,4,6
)
on the
first core pin (0).
As there is one MK gradation between
each of the figures (
0-2; 2-4; 4-6
), you
must insert
3 MK wafers
with a length of
0.8 mm
here.
On the second
core pin
(3)
you must in-
sert
1 MK wafer
with a length of
0.8 mm
(one MK gradation
3-5
).
Do not place
any MK wafers
on the
third
(1) and fourth core pin (2)
in this case.
You must place
1 MK wafer 1.6 mm
long
on the
fifth core pin
(1),
as there are two
MK gradations here (
1-5
).
Please do not add any
HS discs
to the
sixth core pin (6)
in this case.
Содержание Sigma Plus
Страница 1: ...EDV Nr 298061 0 gb 08 09 Rev D Assembly Instructions Key system Sigma Plus Profile 145 ...
Страница 2: ...Notes ...
Страница 4: ...Contents 2 WARRANTY 46 WORKSHEET 47 ...
