9
3.3 Belt Tracking Adjustment: (
IF NEEDED. DO NOT ADJUST OUT OF BOX
)
•
Connect the power cord to a ground circuit. Ensure the red Safety Key is in place. Power on the
MiniPacer with the power switch (reset/off circuit breaker). Press the START/STOP button on your
computer. The computer will countdown ‘3,2,1’ and start moving at the minimum speed (0.5).
•
At minimum speed, check the belt from the backside and see if there is a drift / shift to either the right
or the left side.
•
If the belt shifts to the right, tighten the left knob and loosen the right knob by using the Belt
Adjustment Knob System until the belt centers (see diagram on bottom left). If belt shifts to the left,
tighten the right knob and loosen the left knob by using the Belt Adjustment Knob System until the
belt is centered (see diagram on bottom right).
•
When adjusting the belt using the Belt Adjustment Knob System, it is important to adjust the belt in
half turn increments. Over adjusting the belt can cause damage to the belt.
If the belt shifts to the
right:
1. The left side does not
have enough tension,
and the right side is fine
- tighten the left knob.
2. The tension of the left
side is fine, the tension
of the right side is too
tight - loosen the right
knob.
The belt shifts to the
right:
1. The left side doesn’t
have enough tension,
and right side is good,
please tighten the left
knob.
2. The tension of the left
side is good, the tension
of right side is too tight,
please loosen the right
knob.
If the belt shifts to the
left:
1. The right side does
not have enough tension,
and the left side is fine -
tighten the right knob.
2. The tension of the
right side is fine, the
tension of the left side is
too tight - loosen the left
knob.
The belt shifts to the
left:
1. The right side doesn’t
have enough tension,
and left side is good,
please tighten the right
knob.
2. The tension of the
right side is good, the
tension of left side is too
tight, please loosen the
