6
3. ASSEMBLY INSTRUCTIONS
3.1 Initial Assembly
Take the MiniPACER out of the box and place it on cardboard, a mattress, or a carpeted surface.
•
Lay the MiniPACER in an open area so you have plenty of room to work.
•
Open legs and lock them into place using the Leg Pins (Bolt Ø6). Make sure they are locked (see
diagram below). You only need to use 2 of the Leg Pins – the additional 2 are used for the incline
feature.
•
Put the overhead bar in place and tighten the 4 screws (M6*15). The upper part can come off if your
dog is too big.
NOTE: Tighten screws a little at a time using the 5mm Hex Key, one by one.
Ø6 Flat Washer / M6*15
Motor cover
Hex bolt M6*10
Motor cover
Ø6 Flat Washer / M6*15
Motor cover
Hex bolt M6*10
Ø6 Flat Washer / M6*15
Motor cover
Plain washer
Φ
6
Motor cover
Ø6 Flat Washer / M6*15
Motor cover
Plain washer
Φ
6
Motor cover
Ø6 Flat Washer / M6*15
Motor cover
