DOGA GX-H Series, Инструкция по эксплуатации

Страница: 10 / 32

Instructions manual / GX-H & GXA-H 40 Volts Screwdrivers
10
10.2 Speed/Angle control & Auto reverse (GXT-H)
Model: GXT150-H, GXT220-H, GXT450-H
One triggering by the lever can make 3 steps operation sequence in a cycle
■
Start, Stop and Direction in a cycle
Step 1
→
2
→
3
Sequence first RUN stop HOLD reverse RUN
Rotating
direction
Clockwise or
Counterclockwise by
F/R switch
Reverse
Activating
Screwdriver run to the
target angle and stops. It
always stops at the set
torque, even it does not
reach the target angle.
delay for
set time
Screwdriver run reverse to
the target angle and stops.
It always stops at the set
torque, even it does not
reach the target angle.
Angle run &
Time delay 29 steps
1/4 to 30 turns
14 steps
0.2 to 3 sec
29 steps
1/4 to 30 turns
- Screwdriver stops Immediately when the lever is released in any sequence.
- Sliding F/R switch works for increasing or decreasing of setting
■
Operating (Work) mode
①
Rotating direction (FOR-REV)
■
PROGRAM mode
①
First run angle (Increase / Decrease) together with "First Run(Speed)" button
②
Time (Increase / Decrease) together with "Stop(Reverse)" button
③
Rotation speed (Increase / Decrease) together with "Speed(First Run)" button
④
Reverse run angle (Increase / Decrease) together with "Reverse(Stop)" button