60327-04/20
BS-5C color ID bit tray
23
3.4 Operating mode configuration
3.4.1 Master mode operation
In this mode, operators can use whichever bit they
require (one at a time). The bit tray selects the
corresponding program on the tool controller.
3.4.2 Slave mode operation
In this mode, when a program is selected (either by the operator or job
manager PLC as DPC Touch), the bit tray shows the operator which bit to use.
3.5 Routing table configuration
Factory setting: bit assignment to the program is direct:
- Program 1 corresponds to location 1
- Program 2 corresponds to location 2
- Etc…
A program number can be defined for each bit.
Содержание BS-5C
