13
Momentary / continuous stimulation:
This function enables you to activate a safe stimulation warning impulses in the receiver
transmitted by two contact points.
The purpose of stimulation impulses is not to hurt the dog, but this impulse is very un-
pleasant for your dog. Your dog will soon create a connection between your command,
an audible beep tone and the unpleasant feeling on the neck.
Later on, you will use only a minimum of these stimulation impulses because the dog
will connect them with disobeying your command.
While transmitting the stimulation impulse, the red LED indicator of the receiver is
emitting a light.
Momentary -
correction impulse takes only 0,1 second no matter how long the button is held.
Continuous stimulation -
a receiver emits a correction impulse as long as the but-
ton is pressed, but for safety reasons, it is limited to 8 seconds.
Choice of stimulation level
It is important to choose the right intensity of the stimulation impulse for your dog,
therefore it is gently adjustable in 40 levels. Because every dog has a different sen-
sitivity, you can not estimate the proper stimulation level in advance. Beginn at the
lowest levels. If your dog does not respond at a low level, increase it gradually until
you can see a moderate reaction. The stimulation impulse should never cause your
dog a pain or a fear.
Light:
For an easy localization of your dog in the dark, this function provides several modes
of LED light. The LED diodes are placed in the transparent receiver housing of the
collar. The transmitter also allows you to set a different interval of flashing when
using two collars at the same time - you can easily spot your dogs according to the
flashing interval (example: a dog A - flashes once in a second and a dog B - flashes
once in two seconds).
TIP:
The command stimulation impulse in level 00 does not emit any stimulation
impulses. If you do not want to use the stimulation impulses, set a short and a long
stimulation impulse on the 00 intensity.
Mode
Light is flashing
Period Limit
1
as long as the button is pressed down and held
0,5 s
30 s
2
after the button is pressed down, the light starts flashing *
2 s
-
3
2 x
0,5 s
-
4
10 x
2 s
-
5
as long as the button is pressed down and held
0,1 s
30 s
6
after the button is pressed down, the light starts flashing *
1 s
-
7
2 x
0,1 s
-
8
10 x
1 s
-
* Flashing is switched off by repetitive pressing down the button
14
