Doepke DSU 8plus, Инструкция по установке и эксплуатации

Страница: 26 / 32

5.3 Input inversion
The DSU 8 plus supports the inversion of the input signals for each
input:
» Input not inverted: the status of the input signal is transmitted on
the Dupline bus without change.
» Input inverted: if the status of the input signal is „low“ („0“), a „1“
will be transmitted on the Dupline bus, if it is „high“ („1“), a „0“.
Setting is performed as follows:
1.
S e t - u p
� I n p u t s �
① ② ③ ④
» Select the menu item indi-
cated alongside by pressing
① or ④.
» Skip to the submenu by
pressing ② or ③.
2.
S e t - u p
� I n v e r s i o n �
① ② ③ ④
» » Select the menu item indi-
cated alongside by pressing
① or ④.
» Skip to the submenu by
pressing ② or ③.
3.
I n v e r t I 1 :
� y e s �
① ② ③ ④
» » Press ① or ④ to select the
input whose threshold you
want to change.
» By pressing ② or ③ you can
then switch on (“yes”) or off
(“no”) the inversion.
» Continue this step until all the
inputs have been set up.
4.
S a v e s e t t i n g s ?
� y e s n o �
① ② ③ ④
» Select the menu item indi-
cated alongside by pressing
① or ④.
» Press ② to save your
changes.
» Press ③ to discard your
changes.
26
Doepke